NETGEAR D7000 User Manual page 76

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
Field
Transfer Mode
DSL Mode
Multiplexing Method
VPI
VCI
Use VLANID
Priority (0 ~ 7)
Bridge Mode
Encapsulation
Login
Password
Service Name
Description
These settings are not disabled but do not apply to a cable or fiber connection. You
can ignore these settings.
Unless you changed the physical WAN interface settings so that the modem router
must use the Ethernet WAN interface (see
Preference on page 199), these settings are not disabled. However, these settings
do not apply to a cable or fiber connection and you can ignore them.
Select the Use VLANID check box and enter the VLAN ID, as indicated by your
ISP.
A VLAN ID might be required if you subscribe to both Internet service and IPTV
service. If your ISP did not provide you with a VLAN ID, leave the Use VLANID
check box cleared, which is the default setting.
If your ISP provided you with a VLAN ID and a priority value, enter the priority value,
which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your ISP did
not provide you with a priority value, leave the default setting (0).
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see
Devices on page 202.
For a PPP over Ethernet (PPPoE) connection, select PPPoE (PPP over Ethernet)
from the menu.
Note PPP over ATM (PPPoA) is not supported for a cable or fiber
connection.
Enter the login name that you use to log in to your Internet service, as indicated by
your ISP.
This login name is often an email address.
Enter the password that you use to log in to your Internet service, as indicated by
your ISP.
Enter the service name that you use to log in to your Internet service, as indicated
by your ISP.
Often, a service name is not required.
Manage the Internet Settings Manually
76
Change the Physical WAN Connection
Enable Bridge Mode for IPTV