NETGEAR D7000 User Manual page 72

Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
Field
Transfer Mode
DSL Mode
Multiplexing Method
VPI
VCI
Use VLANID
Priority (0 ~ 7)
Bridge Mode
Account Name
Domain Name
Internet IP Address or IPTV IP Address (depending on your selection in Step 7)
Get Dynamically from ISP
Use Static IP Address
Use IP over ATM (IPoA)
Description
These settings are not disabled but do not apply to a cable or fiber connection. You
can ignore these settings.
Unless you changed the physical WAN interface settings so that the modem router
must use the Ethernet WAN interface (see
Preference on page 199), these settings are not disabled. However, these settings
do not apply to a cable or fiber connection and you can ignore them.
Select the Use VLANID check box and enter the VLAN ID, as indicated by your ISP.
A VLAN ID might be required if you subscribe to both Internet service and IPTV
service. If your ISP did not provide you with a VLAN ID, leave the Use VLANID
check box cleared, which is the default setting.
If your ISP provided you with a VLAN ID and a priority value, enter the priority value,
which is a number from 0 to 7.
You can enter a priority value only in combination with a VLAN ID. If your ISP did
not provide you with a priority value, leave the default setting (0).
This setting is an option that applies to the IPTV interface only.
For information about configuring bridge mode, see
Devices on page 202.
Enter the account name, as indicated by your ISP. This name might also be called
the host name.
If your ISP did not provide you with an account name or host name, leave the default
setting.
Enter the domain name, as indicated by your ISP.
If your ISP did not provide you with a domain name, leave this field blank.
Your ISP uses DHCP to assign your IP address. Your ISP automatically assigns
these addresses.
Enter the IP address, IP subnet mask, and gateway IP address that your ISP assigned
you for static IP address service.The gateway is the ISP router to which your modem
router connects.
These settings are not disabled but do not apply to a cable or fiber connection. You
can ignore these settings.
Manage the Internet Settings Manually
72
Change the Physical WAN Connection
Enable Bridge Mode for IPTV