Setting the Control Unit
3.
Using a small flat-tip screwdriver, adjust the switches
on the (accessory) control unit to the locations
shown. Using isopropyl alcohol on a shop towel,
clean the area where the protective tape will attach
control. Remove the adhesive backing, and attach
the protective to the control unit.
NOTE:
•
The switches must be selected before the
control unit is plugged in.
•
If the switch setting is not correct the remote
engine starter will not operate correctly.
•
If adjusting the switches with the control unit
installed in the vehicle, touch the metal part of
the screwdriver to any metal part of the vehicle
to discharge any static electricity.
•
If you change the switch settings with the unit
connected, you must disconnect the unit then
reconnect it before the settings change.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREW-
DRIVER
SWITCHES
SWITCHES
SW:1 RR Junction unit -----------------------> OFF
SW:2 Trunk or Tailgate ----------------------> OFF
SW:3 Smart Entry -----------------------------> OFF
SW:4 Horn or Buzzer Answerback ------> OFF
SW:5 Trunk Main SW -------------------------> OFF
SW:6 Reserve ----------------------------------> ON
© 2008 American Honda Motor Co., Inc. – All Rights Reserved.
4.
Discharge any
static electricity.
5.
The switches must
be selected before
the control unit is
plugged in.
SET
AII 38576-38846 (0802)
SW:1 RR Junction Unit
SW:2 Trunk or Tailgate
SW:3 Smart Entry
SW:4 Horn or Buzzer Answer Back
SW:5 Trunk Main SW
SW:6 Reserve
Remove the driver's dashboard lower cover (eight
clips, two hooks, and disconnect the vehicle
connector).
VEHICLE
CONNECTOR
8 CLIPS
V6 Model only: remove the driver's dashboard under
cover (three clips and one pin).
3 CLIPS
PIN
DRIVER'S DASHBOARD
UNDER COVER
DRIVER'S DASHBOARD
LOWER COVER
2 HOOKS
6D1803AY
6D18040Y
3 of 23