Makita LS0714 Technical Information page 15

R
epair
7. Laser section can be disassembled as shown in Fig. 18-3.
Fig. 18-3
Block C
Torsion spring 9
Block B
Pan head screw M3x10
2) Remove torsion spring 9 and block C
by unscrewing pan head screw M3x10.
[20] Assembling laser section (exclusively for LS0714FL/ LS0714L)
1. Mount torsion spring 9 and block B to block C and secure them with pan head screw M3x10. Refer to Fig. 19-1.
Make sure that block C and block B can move in torsional direction.
2. Mount torsion spring 9 and laser circuit to block B, and secure them with pan head screw M3x10. Refer to Fig. 18-3.
Make sure that block B and laser circuit can move in torsional direction. See Fig. 19-2.
Fig. 19-1
Block C
Torsion spring 9
Pan head screw M3x10
3. For easy adjustment of irradiated angle of laser beam from now on, drive hex socket set screws M4x6 until their
head portions come to the same level with the surfaces of block C and laser circuit. See Fig. 19-3.
4. Hold the lead wires of laser circuit between two ribs of block C.
Fig. 19-3
Block C
Hex socket
set screw M4x6
1) Unscrewing pan head screw M3x10 allows
to remove torsion spring 9 and laser circuit.
Pan head screw
M3x10
Block B
Block C
Hex socket
set screw M4x6
Hex socket
set screw M4x6
Laser circuit
Laser circuit
Laser circuit
Torsion spring 9
Fig. 19-2
Block C
Torsion spring 9
See Fig. 19-4.
Fig. 19-4
Laser circuit
P 15/ 26
Block B
Laser circuit
Ribs
Block C