Makita LS0714 Technical Information page 11

R
epair
[11] Disassembling positive lock mechanism of turn base
1. Remove grip 32.
2. Separate lock lever plate and lock lever from turn base by removing tapping screw bind CT 4x16. See Fig. 10-1.
3. Turn lock pin in order to face pin 3 to vertical direction. And remove pin 3 while pushing compression spring 6
toward the grip side. See Fig. 10-2.
4. By pulling off lock pin from turn base, compression spring 6 can be removed from lock pin.
Fig. 10-1
Grip 32 Lock lever plate
Lock lever
[12] Assembling positive lock mechanism of turn base
Do the reverse of disassembling procedure with the following attention:
1. The protrusion of lock lever plate has to face the grip side.
2. Apply grease to the threaded portion of the grip.
See Fig. 11.
Fig. 11
Grip 32
Apply grease here.
Projection of lock lever plate
Lock lever plate
Lock lever
Tapping screw
bind CT 4x16
Tapping screw bind CT 4x16
Screw holes
Fig. 10-2
Compression
spring 6
Pin 3
Push compression spring in the direction
designated with arrow (toward grip side).
P 11/ 26
Lock pin