Makita LS0714 Technical Information page 12

R
epair
[13] Mounting stopper plate to arm holder
Mount stopper plate as illustrated in Fig. 12.
Fig. 12
Arm holder
Stopper plate
Flat washer 6
[14] Mounting ring 26 and set screw M4x8
1. Insert ring 26 into the hole of arm. See Fig. 13.
2. Drive set screw M4x8 into the screw hole of arm by screwing thumb screw M6x33 with hex wrench.
Stop driving the set screw at the same time it reaches surface A.
Fig. 13
Screw hole for
thumb screw M6x33
Hex wrench
[15] Adjusting arm for smooth pivot action
1. Adjust hex lock nut M10x17 so that arm can pivot smooth without backlash. See Fig. 14-1.
2. Mount lever 100 and the relevant parts to arm with keeping the lever angle in lock position as Fig. 14-2.
Fig. 14-1
Arm
Hex lock nut
M10-17
Arm holder
Insert this tail into the small hole
of stopper plate.
Pan head screw M5
Torsion spring 8
Arm
Ring 26
Set screw M4x8
Screw hole of
arm
Surface A
Fig. 14-2
Approx
horizontal plane
Thumb screw M6x33
Ring 26
Arm
Flat washer 10
Lever 100
10° against
Pan head screw M4x10
P 12/ 26
Arm holder
Stopper plate
Flat washer 6
Torsion
spring 8
Pan head
screw M5
Hex wrench
Set screw M4x8
Arm
Compression spring 5
Hex nut M10-17