Honeywell TH8320R1003 Vision Pro 8000 Product Data page 16

®
VISIONPRO 8000 WITH REDLINK™
3. Press "No" at the next screen to save and exit, or press
"Yes" if you need to connect additional thermostats to the
Portable Comfort Control. See Fig. 46.
NOTE: The Portable Comfort Control can control up to 16
thermostats.
YES
CONNECT MORE?
Fig. 46. Connect additional thermostats to Portable
Comfort Control.
4. Follow the same linking procedure as above to connect
additional thermostats.
ERROR MESSAGES:
E1 29: Incompatible device cannot be connected.
E1 34: Low RF signal. Move device to a different location and
try again.
E1 38: Make sure the thermostat, EIM, or TrueZONE Wireless
Adapter is in Wireless Setup mode, and the Portable Comfort
Control is at least 2 feet away (600 mm).
NOTE: The linking procedure will time out if there is no
keypress for 30 minutes. To begin again, press
and hold in the lower right corner of the screen
until the display changes (about 3 seconds). See
Fig. 47.
Fig. 47. Restarting the linking process.
68-0312—01
NO
M28482
Press and hold
the blank space
(or arrow may be
present)
16
RedLINK Internet Gateway
1. Press and quickly release the button on the bottom of the
Internet Gateway. After a short delay, the RedLINK sta-
tus light will glow steady green.
Fig. 48. RedLINK Internet Gateway connect button.
NOTE: The Internet Gateway must be registered online
before use at www.mytotalconnectcomfort.com.
Enter the MAC ID and MAC CRC numbers located
on the bottom of the Internet Gateway. For addi-
tional information, see instructions provided with
the device.
TrueSTEAM
1. Press and quickly release the CONNECT button on
THM4000 Wireless Adapter. After a short delay, the
CONNECTED status light will glow steady green.
THM4000R1000
Fig. 49. Connect button on TrueSTEAM wireless adapter.
MCR32943
TrueSTEAM
MCR34523