Makita UH520D Technical Information page 13

W
iring diagram (cont.)
Fig. D-5
Put the following Lead wires
between Rib A and Boss.
Do not put the Lead wires on this Rib.
Lead wires
Flag connector
Flag connectors have to be connected so that
their lead wires are passed over the center of
Terminal.
Wiring in Housing set
Wiring of LED warning lamp for battery
Face the projected portion of LED Lamp to Front grip side.
LED Lamp
Rib A
Boss
Rib
Switch
Wiring to Terminal
the center of Terminal
Groove
Rib B
Rib C
Route the Lead wires (white, orange, purple) between
the Rib and inner wall of Housing set.
Lead wire
holder
Rib
Motor housing
Lead wires
Flag connector
Receptacle
Face their connectors to Housing L side
and connect their lead wires to Switch
terminals.
Their lead wires have to be routed
between Housing L and Switch.
Put LED Lamp's Lead
wires into groove.
Put Lead wires between
Rib B and Rib C.
Fix the Lead wires (white, orange,
purple) with Lead wire holder.
Switch on Front
grip side
Wiring to Switch
on Front grip side
Housing L side
Connectors
P 13/ 13