Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Parameters
•
address—Specifies the client IP address.
•
mask—Specifies the client network mask.
prefix-length—Specifies the number of bits that comprise the address
•
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
unique-identifier—Specifies the distinct client identification in dotted
hexadecimal notation: Each byte in a hexadecimal character string is two
hexadecimal digits. Bytes are separated by a period or colon. For example,
01b7.0813.8811.66.
hardware-address—Specifies the MAC address.
•
Default Configuration
DHCP hosts are not configured.
Command Mode
DHCP Pool Host Configuration mode
Example
The following example manually binds an IP address to a Dynamic Host
Configuration Protocol (DHCP) client.
Console(config-dhcp)#
01b7.0813.8811.66
address (DHCP Network)
Use the address DHCP Pool Network Configuration mode command to
configure the subnet number and mask for a Dynamic Host Configuration
Protocol (DHCP) address pool on DHCP Server. Use the no form of this
command to remove the subnet number and mask.
Syntax
{network-number | low low-address high high-address} {mask |
address
prefix-length}
no address
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
660
DHCP Server Commands
CLI\files\DCHP_Server.fm
10.12.1.99 255.255.255.0
address
Advertisement
Table of Contents
