Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the port priority of port gi1/0/1 to 144.
Console(config)#
Console(config-if)#
spanning-tree mst cost
Use the spanning-tree mst cost Interface Configuration (Ethernet, Port-
channel) mode command to configure the path cost for multiple spanning-
tree (MST) calculations. If a loop occurs, the spanning tree considers path
cost when selecting an interface to put in the forwarding state. Use the no
form of this command to restore the default configuration.
Syntax
spanning-tree mst
no spanning-tree mst
Parameters
•
instance-id—Specifies the spanning-tree instance ID. (Range: 1–15)
•
cost—Specifies the port path cost. (Range: 1–200000000)
Default Configuration
Default path cost is determined by the port speed and path cost method
(long or short) as shown below:
Interface
Port-channel
Gigabit Ethernet (1000 Mbps)
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
470
Spanning-Tree Commands
CLI\files\Spanning-Tree.fm
gigabitethernet 1/0/1
interface
spanning-tree mst
instance-id
cost
cost
instance-id
cost
1
port-priority
Long
20,000
20,000
144
Short
4
4
Advertisement
Table of Contents
