Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Power over Ethernet (PoE)
Commands
power inline
Use the power inline Interface Configuration mode command to configure
the inline power administrative mode on an interface.
Syntax
{auto | never}
power inline
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
•
never—Turns off the device discovery protocol and stops supplying power
to the device.
Default Configuration
The default configuration is set to auto.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example turns on the device discovery protocol on port 4.
Console(config)# interface
Console(config-if)# power inline auto
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\PoE.fm
gigabitethernet 1/0/4
Power over Ethernet (PoE) Commands
22
357
Advertisement
Table of Contents
