Chapter 4 — Configure the Printer
How to Configure the Printer with SmartSystems
About Printer Profiles
Save a Printer Profile from the Web Page
38
•
If your printer uses the IPL programming language, include
commands between the start of text character <STX> and end of text
character <ETX>. For example, this IPL command changes your
media setting to labels with gaps:
<STX><SI>T1<ETX>
For more information, see the
SmartSystems is a device management tool that you can use to
configure printer settings. The printer ships loaded with the
SmartSystems client. The console is part of SmartSystems and is
available from
www.intermec.com/products/smrtsysfoundation/
index.aspx.
After you change printer default settings to meet your needs, you can
save those settings as a printer profile. The printer supports multiple
profiles that you can save and load at any time. For example, you can
create one profile to use when you are printing on continuous label
stock, and a different profile to use when you are printing on label stock
with gaps.
These printer settings are not saved in a profile:
•
IP address for either IPv4 or IPv6 networks
•
Media calibration settings for the label stop sensor
•
Remote port or remote host values for a remote computer accessing
the printer through raw TCP
From the printer Web page, you can save printer settings as a profile that
you can load from the printer memory at any time.
1 Log in to the printer Web page. For help, see
from the Web Page" on page
2 Click the Configure tab.
3 Select System Settings > General.
4 Click Save As Profile.
IPL Command
Reference.
"Configure the Printer
36.
PM42 Mid-Range Printer User Manual