Honeywell PM42 User Manual page 25

PM42 Mid-Range Printer User Manual
3 Load a media roll onto the media supply hub. Make sure you push
the roll all the way against the inner wall of the printer and adjust the
edge guide and the dancer guide to hold the media in place.
4 Route the media through the print mechanism.
5 Adjust the printhead balance. For help, see
Balance" on page
6 Turn the printhead lift lever clockwise to close the printhead.
7 Adjust the label gap and black mark sensor. The sensor LED should
line up with the center of the media. For help, see
Gap and Black Mark Sensor" on page
8 Close the media cover.
9 Press the Print button to advance the media.
10 Configure the printer for the correct media type (media with gaps,
black mark, continuous fixed length, or continuous variable length).
11 Calibrate the sensors:
• From the printer Main Menu select Wizards > Calibration >
Media.
• From the printer web page select Services > Media Calibration.
12 Configure the start and stop adjust settings.
Chapter 2 — Set Up the Printer
70.
"Adjust the Printhead
"Adjust the Label
72.
17