Led Lights; Condensation Build-Up On The Inside Of The Lens - Toyota VIOS Owner's Manual

508
7-3. Do-it-yourself maintenance
■

LED Lights

The front position lights (LED type), daytime running lights (if equipped), stop/
tail lights (LED type) and high mounted stoplight (LED type) consist of a num-
ber of LEDs. If any of the LEDs burn out, take your vehicle to your Toyota
dealer to have the light replaced.
■

Condensation build-up on the inside of the lens

Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact your Toyota dealer for more information in the
following situations:
● Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
●
■ When replacing light bulbs
P. 487
WARNING
■ Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
●
turning off the lights.
The bulbs become very hot and may cause burns.
● Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
● Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
Do not attempt to repair or disassemble light bulbs, connectors, electric
●
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
■ To prevent damage or fire
● Make sure bulbs are fully seated and locked.
Check the wattage of the bulb before installing to prevent heat damage.
●
VIOS_OM_GE_OM52L06E(TMT)_OM99V20b(TDB)_OM52L61E(TMP)_0D053(IMC)