Bumpers; Plated Portions - Toyota VIOS Owner's Manual

■

Bumpers

Do not scrub with abrasive cleaners.
Plated portions (if equipped)
■
If dirt cannot be removed, clean the parts as follows:
Use a soft cloth dampened with an approximately 5% solution of neutral
●
detergent and water to clean the dirt off.
● Wipe the surface with a dry, soft cloth to remove any remaining moisture.
● To remove oily deposits, use alcohol wet wipes or a similar product.
WARNING
When washing the vehicle
■
Do not apply water to the inside of the engine compartment. Doing so may
cause the electrical components, etc., to catch fire.
■ When cleaning the windshield (vehicles with rain-sensing windshield
wiper)
Set the wiper switch to off.
If the wiper switch is in "AUTO", the wip-
ers may operate unexpectedly in the fol-
lowing situations, and may result in
hands being caught or other serious inju-
ries and cause damage to the wiper
blades.
When the upper part of the windshield where the raindrop sensor is
●
located is touched by hand
● When a wet rag or similar is held close to the raindrop sensor
If something bumps against the windshield
●
● If you directly touch the raindrop sensor body or if something bumps into
the raindrop sensor
Precautions regarding the exhaust pipe
■
Exhaust gases cause the exhaust pipe to become quite hot.
When washing the vehicle, be careful not to touch the pipe until they have
cooled sufficiently, as touching hot exhaust pipe can cause burns.
VIOS_OM_GE_OM52L06E(TMT)_OM99V20b(TDB)_OM52L61E(TMP)_0D053(IMC)
7-1. Maintenance and care
423
Off
7