Wlsn Outdoor Siren - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
10.16

wLSN Outdoor Siren

Specifications
868 MHz
Wire Gauge
Power
Outdoor Modulation
Sounder
EN50131-1
Configuration
Use the Outdoor Siren DIP switches to configure the siren for compliance with the laws of the
installation country. Refer to Figure 10.6, Page 91.
Figure 10.6 Outdoor Siren Configuration Switches
Refer to the following table for configurations allowed by the DIP Switch Settings.
Configuration Region
OFF/OFF Default
ON/OFF Spain
ON/ON Belgium
OFF/ON Reserved
Table 10.9 Outdoor Siren DIP Switch Settings
Bosch Security Systems, Inc.
ISW-BSR1-WOX
0.14 mm to 1.5 mm
Two 2 x 13Ah (3.6 VCC nominal)
1400 – 1600 Hz, excursion of 200 Hz
90 to 105 dB at 1m
EN Environmental class IV outdoor
DIP Switches Configuration
– Siren is limited to 90 sec.
– Flashes every 1.5 sec from 0 - 90 sec of the alarm.
– Flashes every 3 sec from 90 sec - 30 min of the alarm.
– Flash stopped after 30 min.
– Siren is activated for 60 sec, then 30 sec of silence, and then
activated for 60 more sec.
– Flashes every 1.5 sec from 0 - 150 sec of the alarm.
– Flashes every 3 sec from 150 sec - 30 min of the alarm.
– Flash stopped after 30 min.
– Siren is limited to 90 sec.
– Flashes every 1.5 sec from 0 - 90 sec of the alarm.
– Flashes every 3 sec from 90 sec - 30 min of the alarm.
– Flashes every 20 sec from 30 min of the alarm until the siren
is turned off.
Reserved for future use.
System Reference Guide
Device Specifications and Overview | en
F01U087835 | 02 | 2008.10
91