Upgrading The Its-Dx4020-G Software; Downloading The Latest Software; Installing The Software With Hyper Terminal - Bosch ICP-EZM2 Easy Series System Reference Manual

70 en | ITS-DX4020-G Communicator Configuration
9.4

Upgrading the ITS-DX4020-G Software

To upgrade the software in the ITS-DX4020-G, you must download the latest ITS-DX4020-G
binary file from the Bosch website to the target PC or laptop, and then use either Hyper
Terminal or Tera Term to install the binary file on the ITS-DX4020-G.
9.4.1

Downloading the Latest Software

1.
2.
3.
4.
5.
6.
7.
9.4.2

Installing the Software with Hyper Terminal

Microsoft
operating systems.
1.
2.
Figure 9.9 Hyper Terminal Send File Window
3.
4.
5.
6.
F01U087835 | 02 | 2008.10
From your Internet browser, go to http://www.boschsecurity.us/en-us/ to open the US
Bosch web site.
Under Online Catalogs, click Intrusion Alarm Systems.
Under Download Library, click Software.
Under Software, click Intrusion Alarm Systems.
Under Intrusion Alarm Systems, click Conettix - Information Transport Solutions.
To the right of ITS-DX4020-G_x.x.x.bin, click EN.
The File Download window opens.
Click Save to save the file to the target PC or laptop.
®
includes Hyper Terminal with the Windows XP
In Windows, click Start→All Programs →Accessories →Communications →Hyper
Terminal.
From the Hyper Terminal menu, click Transfer→Send File.
The Send File window opens.
Click Browse and go to the location where you downloaded the ITS-DX4020-G binary file.
In Protocol, select Xmodem.
Click Send to start the software upgrade.
When the software upgrade is complete, close Hyper Terminal, and remove the jumper
plug from the CONFIG jumpers on the ITS-DX4020-G. The ITS-DX4020-G restarts.
System Reference Guide
®
operating system, and earlier
Bosch Security Systems, Inc.
Easy Series