Usb Option Menu - Bosch ICP-EZM2 Easy Series System Reference Manual

68 en | ITS-DX4020-G Communicator Configuration
The main menu shows all current configuration settings first. An asterisk in front of a
configuration item indicates that its setting has been changed during the current session.
The content of the main menu constantly scrolls. When a user performs a new action, any
resulting response from the user interface appears at the end of the menu.
9.3.4

USB Option Menu

Refer to Table 9.5 for a description of the USB option menu items.
To see the USB option menu, refer to Figure 9.8, Page 67.
Option
1 Change password
2 Change log level
3 View log
4 Exit without Save
5 Restore Factory defaults
6 Save and Reboot
7 Upgrade Software
8 Change Basic parameters
9 Change Advanced parameters 9
Table 9.5 ITS-DX4020-G Menu Options
At a configuration screen, items are presented one at a time with the current value inside [ ]
brackets. If you press [Enter] without entering a new value, the current value is unchanged.
To go to a specific menu option, enter the appropriate menu item number and press [Enter].
F01U087835 | 02 | 2008.10
Press to Description
Select
1 To change the login password, enter the old password first, and then
enter the new password twice. The second entry is to confirm the new
password.
Passwords must be 4-15 characters long, and they are case-sensitive.
0-9, A-Z, a-z, and special characters are allowed.
2 Change the debugging level shown on the View Log screen.
3 View the debugging log. Press any key to exit.
4 Return to the user interface login screen. All configuration changes that
were made are lost and are replaced with the default values.
5 Select Yes to restore all factory default configurations.
When prompted, remove the plug from the CONFIG jumper pins to
restart the ITS-DX4020-G.
6 Select Yes to save all configuration changes.
When prompted, remove the plug from the CONFIG jumper pins to
restart the ITS-DX4020-G.
7 Select this option to upgrade the software in the ITS-DX4020-G.
Refer to Section 9.4 Upgrading the ITS-DX4020-G Software, page 70.
8 To change a basic parameter:
1. Select the parameter.
2. Enter the desired value and press [Enter].
Refer to Table 9.6, Page 69 for basic parameters.
Select to change advanced parameters.
Refer to Table 9.7, Page 69 for advanced parameters.
System Reference Guide
Easy Series
Bosch Security Systems, Inc.