Wlsn Pir And Dual Motion Detectors - Bosch ICP-EZM2 Easy Series System Reference Manual

82 en | Device Specifications and Overview
10.8

wLSN PIR and Dual Motion Detectors

The PIR Motion Detector (ISW-BPR1-W13PX) uses an infrared sensor. The Dual Motion
Detector uses (ISW-BPR1-W13PGX) both PIR and microwave technology.
A cover-and-wall tamper switch transmits a tamper signal when the cover is removed from its
base, or when the unit is pulled away from the wall.
An LED provides status for Walk Test, RFSS, and Discovery Modes.
Specifications
868 MHz
915 MHz
PIR Motion Detector Power/
Voltage
Dual Motion Detector Power/
Voltage
EN50131-1
Sensitivity Settings
Sensitivity settings are set at the control panel. Refer to the control panel's documentation for
detailed information.
1.
2.
NOTICE!
i
The Dual Motion Detector's microwave motion sensor is factory adjusted to sense motion to
at least 11 m.
3.
F01U087835 | 02 | 2008.10
PIR: ISW-BPR1-W13PX
Dual: ISW-BDL1-W11PGX, ISW-BDL1-W11PHX, ISW-BDL1-W11PKX
PIR: ISW-BPR1-W13PY
Dual: ISW-BDL1-W11PGY, ISW-BDL1-W11PHY, ISW-BDL1-W11PKY
Four AA 1.5 V alkaline batteries
Six AA 1.5 V alkaline batteries
Security Grade 2, Environmental Class II
Standard Sensitivity
Use this setting when pets are present in the area to be monitored. Standard sensitivity
provides excellent detection performance and is the least sensitive to false alarms.
Intermediate Sensitivity
Only use this setting in non-pet installations where environmental disturbances are
minimal. Intermediate sensitivity provides the highest level of detection performance.
Setting the Dual Motion Detector's Microwave Range Adjustment
a. If the microwave coverage needs adjustment (red or yellow LED does not light),
increase or decrease the microwave range as needed (using the back of the device).
b. Repeat the Walk Test.
c. Repeat Steps a and b until the required coverage is met.
System Reference Guide
Easy Series
Bosch Security Systems, Inc.