2. Service Settings in Test Mode
The Service Settings in Test Mode are to be operated by service technicians only. The unique
requirements of each user can be set. (When a PC Board is replaced, these settings must be
performed on the new PC board so that the same operations can be used. Therefore, output a
Function List, Dial Number List, etc. before starting Service Settings in Test Mode.)
Single use service mode operation:
NOTE:
When you enter the service mode using this procedure, the facsimile automati-
cally returns to the standby mode after each test is completed.
(1)
Press the following keys in order:
[MENU] [ * ] [#] [ * ] [ * ]
MMM-DD-YY DDD HH:MM
RESIDUAL MEMORY 100%
Use the [ ↑ ] or [ ↓ ] keys to select the "2.MAINTENANCE" item row, then press the
(2)
[ENTER] key, or press [2] on the dial key pad. The screen below is displayed.
01.MEMORY CLEAR
02.SET FUNCTION
03.MODEM WRITE
04.SET CONT. LEVEL ↓
Use the [ ↑ ] or [ ↓ ] keys, or numeric keys, to select "02.SET FUNCTION" item row, then
(3)
press the [ENTER] key.
SET FUNCTION
FUNC0 =XXXXXXXX
Bit 7 is the left most digit as shown on the LCD display. By entering 1 or 0 in the bit
corresponding to the desired function, you can change the setting of that function. Press
the [ENTER] key to store the new setting and advance to the next function.
NOTE:
Use the [ENTER] key to advance to the next function. Use the [>] key to
move to the next bit. Use the [<] key to move to the previous bit, if already
at bit 7 (the left digit), the [<] key will move to the previous function.
March 2000 © TOSHIBA TEC
Change to
service mode.
→
←
Displays the numeric value currently set (cannot be changed).
←
XXXXXXXX
Displays the numeric value to be entered now (can only be
↑
↑
altered at the point of the blinking cursor).
Bit 7
Bit 0
1.FUNCTION TEST
2.MAINTENANCE
3.SERVICE LIST
05.ERR COUNTER SHIFT
06.EDGE REGISTRATION
07.DOC. TRANSMISSION
08.FUSER SETTING
4-59
DP120F/DP125F Function Settings