Adjusting The Clutch Release System; Checking The Carburetor Jointand Intake Manifold - Yamaha T135SE Service Manual

ADJUSTING THE CLUTCH RELEASE SYSTEM/

CHECKING THE CARBURETOR JOINT AND INTAKE MANIFOLD
1
2
CLEANING THE AIR FILTER ELEMENT/
6. Install:
EAS00086
ADJUSTING THE CLUTCH RELEASE
SYSTEM
1. Adjust:
a. Loosen the locknut 1 .
b. Turn the adjusting screw
c. Tighten the locknut.
NOTE:
Hold the adjusting screw and tighten the lock-
nut.
EAS00094
CHECKING THE CARBURETOR JOINT
AND INTAKE MANIFOLD
1. Remove:
1
2. Check:
2
3-21
http://www.motorcycle.in.th
9 center panel (lower)
Refer to "INSTALLING THE CENTERPAN-
ELS".
9 clutch release system
then turn the adjusting screw out the speci-
fied number of turns.
Adjusting screw:
1/8 turns out
8 Nm (0.8 m•kg, 6.0 ft•lb)
9 side cowlings (left and right)
9 center panels (upper and lower)
9 front cowling
9 rear cowlings (left and right)
9 inner panel
Refer to "COVERS".
9 carburetor joint 1
9 intake manifold 2
Cracks/damage → Replace.
Refer to "CARBURETOR" in chapter 6.
CHK
ADJ
2 in completely,