Yamaha T135SE Service Manual page 258

2
1
http://www.motorcycle.in.th
FRONT BRAKE
2. Install:
9 copper washers 1
9 brake hose 2
9 union bolt
w
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING".
NOTE:
Turn the handlebar to the left and right to make
sure the brake hose does not touch other parts
(e.g., wire harness, cables, leads). Correct if
necessary.
3. Fill:
9 brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT 3 or 4
w
99
Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor brake
performance.
99
Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
99
When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the boil-
ing point of the brake fluid and could cause
vapor lock.
cC
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
7-28
CHAS
26 Nm (2.6 m·kg, 19 ft·lb)