1
2
1
a
HANDLEBAR
3. Install:
9 bushings
9 washers
9 handlebar
9 wire harness strap
Refer to "CABLE ROUTING" in chapter 2.
4. Install:
9 handlebar grip
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
w
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
5. Install:
9 throttle grip 1
9 throttle cable 2
9 throttle housing
NOTE:
Lubricate the inside of the throttle grip with a thin
coat of lithium-soap-based grease and install it
onto the handlebar.
6. Install:
9 lever holder 1
NOTE:
Align the projection
switch with the hole in the handlebar.
w
Make sure the throttle grip operates smooth-
ly.
7-43
http://www.motorcycle.in.th
CHAS
23 Nm (2.3 m·kg, 17 ft·lb)
a on the right handlebar