CHECKING THE BULBS AND BULB SOCKETS
A
B
C
D
EAS00732
CHECKING THE BULBS AND
BULB SOCKETS
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continu-
ity between the terminals.
Damage/wear → Repair or replace the
bulb, bulb socket or both.
Improperly connected → Properly connect.
No continuity → Repair or replace the bulb,
bulb socket or both.
TYPES OF BULBS
The bulbs used on this vehicle are shown in the
illustration on the left.
9 Bulbs A and B are used for the headlights
and usually use a bulb holder that must be
detached before removing the bulb. The major-
ity of these types of bulbs can be removed
from their respective socket by turning them
counterclockwise.
9 Bulb C is used for turn signal and tail/brake
lights and can be removed from the socket by
pushing and turning the bulb counterclockwise.
9 Bulbs D and E are used for meter and indica-
E
tor lights and can be removed from their
respective sockets by carefully pulling them
out.
8-7
http://www.motorcycle.in.th
ELEC