Description Of Commands - Nokia ESB26 User Manual

21.
This setup allows cross-VLAN multicast frames to be sent from VLAN 2 to users on other
VLANs through registered receiver ports.

Description of Commands

MVR Global Configuration Commands
Table 21-1 summarizes the MVR configuration commands available in global Configuration
mode.
Table 21-1 MVR Global Configuration Commands
C o m m a n d D e s c r i p t i o n
mvr
Enables MVR. The
mvr mode Specifies whether the mode of operation is static or dynamic.
mvr group Statically configures an MVR group IP multicast address or a sequence of MVR
group IP multicast addresses on the switch.
mvr querytime Sets the maximum time to wait for IGMP report memberships on a receiver port.
mvr vlan Specifies the VLAN on which MVR multicast data is expected.
MN700004 Rev 01
Multicast VLAN Registration (MVR)
Figure 21-1 Example of an MVR Configuration
no
form of this command disables MVR.
256