Nokia ESB26 User Manual page 102

10.
Notification Configuration Commands
In order to send notifications to the management station, perform the following steps:
1. Enable the SNMP agent (if it is disabled).
2. Create a view, group and user that includes the notification variables with notify
access right
3. Create a tag that includes all required notifications. See Defining SNMP
Notification.
4. Create a target parameter that links a parameter name to the user. See Defining
the Notification Target Parameter.
5. Create a target address that links the parameter to a specific IP address. See
Defining the Notification Target Address.
Table 10-4 lists the configuration commands for the SNMPv3 Agent. By default, no
notifications will be sent by the switch.
NOTE
The user configured to receive the notification must have notify access (in the view) to all
variables participating in the notification.
Table 10-4 Agent Notification Configuration Commands
C o m m a n d
snmp-server notify
snmp-server target-param
snmp-server target-addr
snmp-server target-profile
snmp-server authentication-failure-
trap
Defining SNMP Notification
The snmp-server notify command, in Global Configuration mode, defines the notification.
The no form of this command disables the notification.
NOTE
The notification name is the same as specified in the MIB (case sensitive).
Command Syntax
device-name(config)#snmp-server notify NAME TAG-NAME
device-name(config)#no snmp-server notify NAME
Argument Description
NAME The notification name, a reserved literal string. The available arguments are
MN700004 Rev 01
SNMP Server Configuration
D e s c r i p t i o n
Defines a notification and specifies the type (trap/inform).
Defines the notification target parameter.
Defines the notification target address.
Includes or excludes a branch of the MIB tree in a
notification profile.
Enables sending authentication-failure traps globally.
91