Applying An Ap Profile; Table 335: Access Point Profile List - D-Link DWS-4026 User Manual

D-Link Unified Access System
Field Description
Profile Name The Access Point profile name you added. Use 0 to 32 characters. Only alphanumeric characters are
allowed. No special characters are allowed.
Click the Radio, SSID, or QoS tabs to configure additional features for the profile.
To copy an existing profile and all of its configurations to a new profile, select the profile with the configuration to copy, enter
a name for the new profile, and click Copy.
To delete a profile, select the profile and click Delete.
To access an existing profile, click the tab with the name of the profile. When you copy a profile, it has the AP settings
configured in the original profile.
To modify any settings within a profile, click the Global, Radio, VAP, or QoS settings for the profile you select and update
the appropriate fields.
The fields to configure are described in the following sections:
• For more information about the fields on the Global page, see
• For more information about the fields on the Radio page, see
• For more information about the fields on the Network page, see
• For more information about the fields on the QoS page, see

Applying an AP Profile

After you update an AP Profile on the Unified Switch, the changes are not applied to the access points that use that profile
until you explicitly apply the profile on the WLAN> Administration > Advanced Configuration > AP Profile > Access
Point Profile Summary page or reset the APs that use the profile.
When you change the VLAN ID for a wireless network, the AP might temporary lose its DHCP-assigned IP
address when you apply the updated profile. If this occurs, the AP goes into Standalone mode. As soon
as the AP regains its IP address from the DHCP server on your network, it resumes normal operation as a
managed AP. You might also see this behavior when you enable or disable a VAP (SSID) and re-apply the
AP profile.
To apply the profile changes to all access points that use a profile, select the profile and click Apply, as the following figure
shows.
Page 516 Configuring Advanced Settings

Table 335: Access Point Profile List

"Profile" on page
"Radio" on page
"Access Point Profile QoS Configuration" on page
Software User Manual
416.
417.
"SSID Configuration" on page
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09
423.
518.