D-Link DWS-4026 User Manual page 111

Software User Manual
12/10/09
Field
Physical Mode
Physical Status
Link Status
Link Trap
Maximum Frame Size
ifIndex
• If you make any changes to the page, click Submit to apply the changes to the system.
Document 34CSFP6XXUWS-SWUM100-D7
Table 43: Port Configuration Fields (Cont.)
Description
Use the pulldown menu to select the port's speed and duplex mode. If the Slot/Port
field is set to All and you apply a physical mode other than Auto, the mode is applied
to all applicable interfaces only:
• Auto: The duplex mode and speed will be set by the auto-negotiation process. The
port's maximum capability (full duplex and 100 Mbps) will be advertised.
• <Speed> Half Duplex: The port speeds available from the menu depend on the
platform on which the D-Link software is running and which port you select. In half-
duplex mode, the transmissions are one-way. In other words, the port does not send
and receive traffic at the same time.
• <Speed> Full Duplex: The port speeds available from the menu depend on the
platform on which the D-Link software is running and which port you select. In half-
duplex mode, the transmissions are two-way. In other words, the port can send and
receive traffic at the same time.
Indicates the port speed and duplex mode.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when link status changes. The
factory default is enabled:
• Enable: Specifies that the system sends a trap when the link status changes.
• Disable: Specifies that the system does not send a trap when the link status changes.
Indicates the maximum Ethernet frame size the interface supports or is configured to
support. The frame size includes the Ethernet header, CRC, and payload. (1518 to
9216). The default maximum frame size is 1518.
The ifIndex of the interface table entry associated with this port. If the Slot/Port field is
set to All, this field is blank.
D-Link Unified Access System
Configuring and Viewing Device Port Information Page 111