Figure 308: Software Download; Table 272: Software Download - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
After you provide the information about the upgrade file, as described in the following table, click Start to begin the upgrade
process. Additional fields appear after the download begins and provide information about upgrade status and success.
The APs automatically reset after the code is successfully downloaded and installed.
Table 272 describes the fields you must complete to upgrade APs.
Field
Server Address
File Path
File Name
Group Size
Image Download Type
Document 34CSFP6XXUWS-SWUM100-D7

Figure 308: Software Download

Table 272: Software Download

Description
Enter the IP address of the host where the upgrade file is located. The host must have a TFTP
server installed and running.
Enter the file path on the TFTP server where the software is located. You may enter up to 96
characters.
Enter the name of the upgrade file. You may enter up to 32 characters, and the file extension
.tar must be included.
When you upgrade multiple APs, each AP contacts the TFTP server to download the upgrade
file. To prevent the TFTP server from being overloaded, you can limit the number of APs to be
upgraded at a time.
In the Group Size field, enter the number of APs that can be upgraded at the same time. When
one group completes the upgrade, the next group begins the process.
Type of the image to be downloaded. D-Link Unified Switch supports only one type - that for
the DWL-8600AP.
D-Link Unified Access System
AP Management Page 447