Sfe Assembly On Flange Cover; Electrical Assembly - Bosch Rexroth SMART Flex Effector Manual

24
4.3

SFE assembly on flange cover

Required components:
• Flange cover
• 6 x screws M4x10
SFE assembly on flange cover
 Position the SFE (1) using the pre-mounted cylinder pin on the flange cover.
 Fasten the SFE (1) onto the flange cover using the screws (2).
Tightening torque of 3.13 Nm (bit TX20).

4.4

Electrical assembly

Damage and short-circuit due to incorrect insertion of the connector
Incorrectly inserted connectors and bent pins may cause damage to the SFE and
short-circuits.
 Ensure that the connector is inserted in the correct position when connecting
the cable, and do not bend any pins.
Damage and short-circuit due to tension on the connection cable
Tension on the connection cable may cause damage to the SFE and short-circuits.
This may cause changes to the behavior of the SFE.
 Avoid tensile stress on the cable.
en
Caution
Caution
4
Assembly