Fitting The Adapter Plate - Bosch Rexroth SMART Flex Effector Manual

22
4.1

Fitting the adapter plate

Required components:
• Adapter plate
• Cylinder pin Ø5
• 3 x screws M6 x 12
Fitting the adapter plate
 Position the adapter plate (1) with the cylinder pin Ø5 (2) at the SFE (3).
 Fix the adapter plate (1) in place on the SFE with the three screws (5) using the drill hole (M6
thread) (4).
When doing so, ensure that the screws used do not protrude beyond the thread length.

Tightening torque 10.25 Nm.

en
4
Assembly