9.6.3
Configuring the Call OnAlarm Mode
Prior to use the Call OnAlarm mode, make sure of the following:
• The installation of the Hydran 201i System is completed.
• The network configuration is defined in the Hydran Host software (see the Hydran Host
Software Manual).
• The Hydran 201Ci Controller's modem is programmed with the telephone number of the
host computer's modem.
To use the Call OnAlarm mode, proceed as follows:
1.
In the Hydran Host software, start the Hydran Host module.
2.
Click Remote.
3.
In the Remote Access window, select the desired power station.
4.
Click Put on Watch.
The following actions are then performed:
1.
The Hydran Host software initializes the host computer's modem.
2.
This modem telephones to the H201Ci's modem.
3.
The Hydran Host software sets to Call OnAlarm the CommMode parameter of all
Hydran 201Ti's in the Hydran 201i System or in the local network.
4.
The Hydran Host software hangs up.
Part 17997
Rev. 6, March 2011
Optional Modem Installation
9-13