Open Customer Programming - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[200] OPEN CUSTOMER PROGRAMMING

Used to open(enable) and close(disable) customer-level programming.
If programming is not opened and an attempt is made to access a system MMC,
the error message [NOT PERMIT] will be displayed. A four digits passcode is required to
access this MMC. Each digit can be 0-9. When opened, this MMC enables access to all
MMCs allowed in MMC 802 Customer Access MMC Number.
No Mode
0 DISABLE
1 ENABLE
CONDITIONS
NONE
DEFAULT DATA
DISABLE
ACTION
1) Press Transfer button and enter 200.
Display shows:
2) Enter passcode.
Correct code shows.
Incorrect code shows.
3) Press Volume button arrow key to select ENABLE
or DISABLE and press Right Soft button.
OR
Dial 1 for ENABLE or 0 for DISABLE.
4) Press Speaker button to advance MMC entry level
and press Volume button to select MMC.
OR
Enter MMC number and press Right Soft button
to enter MMC.
5) Press Transfer button to exit.
2-44
Open(enable) customer-level programming
Close(disable) customer-level programming
Description
DISPLAY
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
DISABLE
ENABLE CUS.PROG.
PASSCODE ERROR
ENABLE CUS.PROG.
ENABLE
201:CUS.PASSCODE
SELECT PROG. ID
© SAMSUNG Electronics Co., Ltd.