Assign Caller Id Trunks (Malaysia And Israel Only) - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[414] ASSIGN CALLER ID TRUNKS (Malaysia and Israel Only)

Allows the system administrator or technician to activate analog loop trunk Caller ID on a
per-trunk basis. Activating Caller ID will delay the incoming ring indication at the operator
by two ring cycles to allow for the collection of the calling party data.
Each trunk has the following options:
No
0 NORMAL
1 CID TRUNK
Bellcore type data
Supports Bellcore type data only for Caller ID, others type will not supports.
Available in Australia, Israel and Italy only.
CONDITIONS
Before setting CID display, check if the RCM or RCM2 option card is mounted on the
MCP card of the OfficeServ 500 system.
The trunk line must be that of a phone service provider that provides CID.
DEFAULT DATA
ALL TRUNKS: NORMAL
ACTION
1) Press Transfer button and enter 414.
Display shows:
2) Dial trunk number.(e.g., 705)
OR
Press Volume button to select trunk and press
Right Soft button to move cursor.
OR
Press ANS/RLS button to select all.
3) Dial 0, 1 or 2 to change options.
OR
Press Volume button to select an option and
press Right Soft button to return to step 2.
2-126
Option
This is not a Caller ID trunk.
This is a Caller ID trunk.
Description
DISPLAY
[701] CID TRUNKS
NORMAL
[705] CID TRUNKS
NORMAL
[ALL] CID TRUNKS
?
[705] CID TRUNKS
CID TRUNK
[705] CID TRUNKS
CID TRUNK
© SAMSUNG Electronics Co., Ltd.