Samsung OfficeServ 500 Programming Manual page 427

No Option
4 CTI LINK OPTION
5 ITP DSP PARA
6 ITP TX GAIN/HSET
7 ITP RX GAIN/HSET
© SAMSUNG Electronics Co., Ltd.
Description
Sets CTI link via LAN option with the system.
0 SMDR REPORT: Sets YES or NO for SMDR data
to CTI link via LAN.
1 UCD REPORT: Sets YES or NO for UCD data to
CTI link via LAN.
2 ALIVE TIME: This is a CTI link via LAN alive
check timer. If this sets 0, the system will not
check link alive.
Sets IP phone DSP parameter of system-wide.
0 M-FRAME: This value determines the
transmission interval time of VoIP packets
generated by the IP phone. This data uses
DOWN = SYS DATA case only on this MMC.
The range is 10~40 ms.
1 JITTER: Decides the minimum time to consider
delay for jitter adjustment. This data uses
DOWN = SYS DATA case only on this MMC.
The range is 10~90 ms.
2 TOS: An eight-bit binary value that will be
utilized by external routers, switches, etc(that
optionally support TOS-bit prioritization)-to
identify the transport-priority value of data
packets generated by the IP phone. This value
can be left at default value(00000) if your
network infrastructure does not support this
method of bandwidth management. This data
uses case only on this MMC.
3 DOWN: Determines data uses system-wide
data or each phone data for IP-based phone
DSP control.
a) SYS DATA: System-wide data will be
used.(MMC 841 data)
b) PHONE DATA: Each phone data will be
used.(MMC 840 data)
Sets IP-based phone Handset TX gain value of
each level. Defaults are followed but depend on
Country
Sets IP-based phone Handset RX gain value of
each level. Defaults are followed but depend on
Country
OfficeServ 500 Programming Guide
(Continued)
Default
-
NO
NO
300 sec
-
10 ms
20 ms
all bits 0
SYS DATA
-
-
2-385