Mgi Parameters - Samsung OfficeServ 500 Programming Manual

[831] MGI PARAMETERS

This MMC provides a mean to configure the Internet Protocol(IP) addressing of the MGI
card(s). This MMC must be utilized MGI card(s) used on the system.
No Parameter
0 IP ADDRESS
1 GATEWAY
2 SUB MASK
3 IP TYPE
4 PUBLIC IP
5 VERSION
6 MAC ADDR
7 CARD RESET
MGI PARAMETERS
- The first 3 parameters: IP ADDRESS, GATEWAY, and SUB MASK-changes to
these parameters will not be applied until the MGI is reset.
- When changing any IP address/value, listed below, three digits must be input for
each(octet) field. Example 192.168.1.10 input must be: 192 168 001 010
© SAMSUNG Electronics Co., Ltd.
Specifies the IP address for the MGI card.
Specifies the designated IP gateway address used for contacting
IP devices beyond the local subnet.
Specifies the IP subnet mask. This parameter is used by the system to
calculate the range if IP devices(subnet) that are within 'direct reach' of
the MGI(without having to go through the designated network IP
gateway).
Defines which IP addressing relationship is used for
communications to and from the MGI card.
0 PRIVATE IP ONLY
1 PRIVATE w PUBLIC
2 PUBLIC IP ONLY
The MGI will originate communications, to IP phones and VoIP
connections outside the local network, using this IP address. If this
IP address sets 0.0.0.0, 255.255.255.255 or default value then this
MGI card uses private IP only. See System IP Type on MMC 830.
No entry required. Used to indicate revision of MGI3 S/W.
For your reference, and cannot be changed. The unique
hardware(MAC)
address of the MGI card.
Prompt to restart MGI card when IP address is changed. This use
for MGI 1 and 2 only, MGI3 is self restart automatically.
OfficeServ 500 Programming Guide
Description
2-363