Table of Contents
Advertisement
General
During transport
During installation
During startup
While running
EMERGENCY STOP, fault
2.6 Product-specifi c safety instructions
• You must not alter the product design principle or reconstruct it.
• Do not put the product unduly under mechanical strain under any circumstances.
Never use the product as a handle or step. Do not place objects on it.
• The product must always be prevented from tipping over.
• Pay attention to the transport instructions on the packaging.
• Inspect the product for visible transport damage.
• Lay the cables and wires so that they are not damaged and no one can trip over
them.
• Always switch the relevant system component to a pressure-free and tension-free
state before installing the product or connecting or disconnecting plugs.
• Secure the component against reconnection.
• Before beginning, make sure that all gaskets and seals of the connectors are
installed properly and are not damaged to prevent fl uids and debris from entering
the product.
• Allow the product to acclimatize for a few hours prior to fi rst-time operation,
otherwise condensation can form inside the housing.
• Make sure that all the electrical and pneumatic connections are assigned or closed.
• Check the security requirements according to DIN EN 619.
• Only start up a fully assembled product.
• Make sure that all pertinent product safety devices are on hand, properly installed
and fully functional. You must not change the position of, circumvent or disable
safety devices.
• Do not touch any moving parts.
• Inspect the product for malfunctioning.
• Make sure that only authorized personnel
– start, operate or modify the functional sequence in the context of the intended
use of the product
– or make adjustments to components or parts.
• Only allow persons authorized by the operator access to the direct operating zone
of the system. This also applies to periods when the product is not in operation.
• Make sure that:
– the access to EMERGENCY STOP devices is free from obstructions,
– all feeding points, workplaces and passageways are kept clear.
• Do not use the EMERGENCY STOP devices for normal stopping action.
• Regularly check the correct operation of the EMERGENCY STOP devices.
• In the event of an error or other irregularities, after an EMERGENCY STOP turn the
product off and secure it against restarting.
• Do not touch any moving parts.
• A resting system is not a safe system because stored energy can be released
unintentionally or due to improper maintenance work.
• Start the system again after an EMERGENCY STOP or malfunctioning only after you
have identifi ed the cause of and have eliminated the fault.
Safety instructions
3 842 358 796/2015-01, MIT: HD 2/H, Bosch Rexroth AG
9/56
Advertisement
Table of Contents
