Bosch Rexroth HD 2/H Assembly Instructions Manual page 20

20/56 Installation
6. Adjust the position of
the base plate between
the conveyor sections.
7. Tighten down the collar
nuts.
8. Remove the eye bolts
Please note:
Optionally, size 1 can be
installed as described in
chapter 1.1.9 on page 21.
NOTICE
Improper adjustment can
result in property damage
The product can be
damaged; the service life
may be adversely affected.

During commissioning
the angle of rotation
must be checked
and precisely set Not
performing this work
may result in the
lift rotate unit being
damaged or cause
premature wear. See
chapter 8.4 "Check
and adjust the rotation
angle of the lift rotate
unit" on page 37.
Bosch Rexroth AG, MIT: HD 2/H, 3 842 358 796/2015-01
=
=
F
7
SW13
M = 25Nm
D
Fig. 7: Adjust lift rotate unit HD 2/H size 1 in section ST 2 (example shown here size 1 180°)
8
8
6
=
=
358 732-29