Installation; Unpacking The Product; Installation Conditions; Installation Position - Bosch Rexroth HD 2/H Assembly Instructions Manual

1 2

7 Installation

7.1 Unpacking the product


Lift the product from its packaging.
Use a lifting aid to lift the product. For example, the eye bolts (X) in the base
plate serve as lifting points for a round sling (see e.g. Fig. 6 on page 19)

Dispose of the packaging material in accordance with the national laws of your
country.

7.2 Installation conditions


During installation the ambient conditions specifi ed in the technical data
(see page 54) must be maintained.
7.2.1

Installation position


Install the product at right angles and parallel to the axis. This ensures proper
functioning and prevents premature wear and tear.
7.2.2

Fixing with T-head bolts

• Mount the transfer systems TS 1, TS 2plus, TS 2pv, TS 4plus, TS 5 and the chain
conveyor systems VarioFlow and VarioFlow S with T-head bolt and collar nut.
• When inserting and tightening, make sure the T-head is in the correct position
in the collar nut. The notch at the end of the screw indicates the position of the
T-head.

1 = insertion position of the T-head bolt into the slot

2 = clamping position of the T-head bolt into the nut

Tightening torque 25 Nm (M8).

7.3 Required tools

• Hex head cap screw SW14
• Hex socket head cap screw SW3, SW4, SW5, SW6.
• Cross recess screwdriver PZ2
• Rubber mallet
• Spirit level
Installation
3 842 358 796/2015-01, MIT: HD 2/H, Bosch Rexroth AG
17/56