Editing Addon Parameters; Overview - Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual

8.5.3

Editing AddOn parameters

8.5.3.1

Overview

Parameters are assigned to the AddOn technology package using the SIMOCRANE CeCOMM
diagnostic program as shown in the following overview:
... or where an error is detected for the relevant parameter set
1)
This parameter set is operative
2)
Figure 8-19 Editing parameter sets in the SIMOCRANE CeCOMM diagnostic program
All the parameters in the parameter list are available in fours, i.e. in the form of four current
parameter sets.
To be able to respond appropriately to the requirements of individual handling tasks (e.g.
changes in acceleration), you can adjust the relevant parameter settings in each of the current
parameter sets. In other words, you can assign four different parameter values in the four
current parameter sets and switch between these sets during operation.
The parameters P100-P102, P106, and P110 are exceptions (see Chapter Changing a
parameter (Page 285)). Changes to the settings of these parameters are always operative
simultaneously in all four current parameter sets.
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
SIMOCRANE CeCOMM commissioning and diagnostic program
8.5 Monitor (tab)
283