Siemens SINAMICS S120 Manual page 111
Cabinet modules liquid cooled
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Cable routing for DRIVE-CLiQ connections and signal cables
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Connect the signal cable at terminal block -X9.
11. Route the DRIVE-CLiQ cable through the cable bushing from the top into the Active Line Module,
Cabinet Modules liquid cooled
Equipment Manual, 04/2020, A5E37067587A
Route the DRIVE-CLiQ/signal cable to the Control Unit into the cabinet from the bottom left.
Use cable ties to secure the cable at suitable points.
Route the cable further in the cabinet to the upper side of the Control Unit. When doing so, route
the cable in a similar manner to the standard cables that have already been installed in the cabi-
net.
Use cable ties to secure the cable at suitable points.
Connect DRIVE-CLiQ/signal cable to the Control Unit.
Route the DRIVE-CLiQ/signal cable to the Active Line Module from the bottom left into the cabi-
net.
Use cable ties to secure the cable at suitable points.
Route the cable further in the cabinet to the upper side of the Active Line Module. When doing
so, route the cable in a similar manner to the standard cables that have already been installed in
the cabinet.
Use cable ties to secure the cable at suitable points.
continue to the DRIVE-CLiQ connection -X400, -X401, -X402 and connect there.
Electrical installation
4.5 Connections
109
Advertisement
Table of Contents
