Signal Connections; Other Connections - Siemens SINAMICS S120 Manual

Electrical installation
4.5 Connections
Use two screwdrivers or a suitable tool in order to relieve the holding springs in the terminal
and then withdraw the connector jumper.
Terminal X530 with connector jumper
Note
Replacing a VSM10 Voltage Sensing Module
When replacing a Voltage Sensing Module VSM10 by one with a different article number,
then inform yourself about the applicable boundary conditions.
4.5.9

Signal connections

Note
Pre-assignment and position of the customer terminal block
The factory setting and description of the customer terminal blocks are documented in the
circuit diagrams.
The location of the customer terminal blocks of the individual Cabinet Modules is
documented in the layout diagrams.
The interfaces or customer terminal blocks are documented for the respective Cabinet
Modules.
DRIVE-CLiQ cables must be locally routed according to the customer-specific engineering
specifications for the entire system.
4.5.10

Other connections

Depending on the range of options installed, further connections may have to be made.
For more information about the interfaces of available options, refer to the relevant sections
in this manual.
98
Relieve the springs and withdraw the connector
jumper
Cabinet Modules liquid cooled
Equipment Manual, 04/2020, A5E37067587A