Installation Procedure - HP 98568A Installation Instruction

HP 2225A ThinkJet Printer
Installation Procedure
The following procedure describes how to connect your HP 2225A ThinkJet
printer to your Series 200/300 computer. Before you do this, however, refer to
the manual(s) that came with your printer to:
• Unpack the printer .
• Check the line voltage.
And now, the installation procedure ...
1. Play It Safe.
Turn your computer and printer off, if they are not already off.
2. Select Your Interface.
Use either the built-in HP-IB interface or an HP 98624A HP-IB Interface.
If using HP-UX, avoid placing the ThinkJet on the same interface used by
your disk or tape drives, if possible.
3. Set the Address.
SKIP?
If this is the first (or only) printer you are connecting to the
interface, you can skip to step 4. The address is preset to 1 and
need not be changed-unless you have changed the address of
some other device on the interface to 1.
a. Find the set of switches to the left of the HP-IB connector. Switches A1
through A5 in this group determine the address.
b. Set the address switches to 4 as shown in Figure 7-1, unless address 4 has
been used elsewhere. Refer to the manual that came with the printer if
you need additional switch settings.
Adding Printers 7-3