Worksheet Entries - HP 98568A Installation Instruction

HP 7957/58/598 and 7961/62/638 Disk Drives
Worksheet Entries
You have now installed your 7957/58/59B or 7961/62/63B Disk Drive.
The following "Worksheet Entries" contain information needed to use your disk
drive with the HP-UX operating system. Refer to the entries for the Interface
you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 6-34.
HP 7957/58/598 Disk Drive or
HP 7961/62/638 Disk Drive
Connected to HP 98625 Disk Interface (Select Code 14)
Path File Major Minor
Device Name
Name *
Type Number Number
Interleave
**
Factor
HP 7957/58/59B or
/dev/dsk/#sO
b 0 OxOeOnOO 1
HP 7961/62/63B
HP 7957/58/59B or
/dev/rdsk/#sO c
4
OxOeOnOO 1
HP 7961/62/63B
*
**
#
is a number that identifies the disk drive (e.g. 0 for the root, 1 for
the next disk installed, etc.). Replace
#
with any unique number, and
use the same number in both the /dev/dsk and /dev/rdsk entries (e.g.
/dev/dsk/1s0 and /dev/rdsk/1s0). Record the numbers on the Chapter 6,
"Mass Storage" tab.
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace
n with a 1 if the address was set to 1, use 4 if the
address was set to 4, and so on.
Adding Mass Storage Devices 6-107