HP 98568A Installation Instruction page 143

HP 98626A RS-232C Interface
Figure 5-22.
10. Set the Modem Line Switches.
a. Find the Modem Line switches, labeled U3 on the interface, by referring
to Figure 5-14.
b. Set these switches as follows:
• If connecting a modem, HP 2686A LaserJet printer, or uucp to this
interface, set these switches to the "Connected" position as shown in
Figure 5-14 .
• If connecting a terminal or bar code reader, set these switches to the
"Always on" position, which is opposite that shown in Figure 5-14.
11. Set the Remote Jumper.
SKIP?
Unless you want to connect your system console terminal to
this interface, you can skip to step 12.
a. Find the remote keyboard jumper by referring to Figure 5-14.
b. If you are connecting a terminal to this interface and would like the
terminal to be the system console, remove the remote keyboard jumper.
Otherwise, leave the jumper intact.
12. Insert the Interface.
a. Remove the painted cover plates from the back of your computer until
you find an empty even-numbered slot. (Slots are numbered from the
top down, so the top-most slot is number 1, the next slot down is
number 2, etc.) Do not remove the silver cover plates from the bottom
of a Series 300 computer.
Adding Interface Cards 5-47