HP 98568A Installation Instruction page 336

HP 7957/58/59S SCSI Disk Drives
Installation Procedure
The following procedure describes how to connect your HP 7957/58/59S to
your Series 300 computer. Before you do this however, refer to the manual(s)
that came with the drive to:
• Unpack the drive .
• Check the voltage selector switch.
And now, the installation procedure ...
1. Play It Safe.
Turn your computer and disk drive off, if they are not already off.
2. Select Your Interface.
The HP 7957/58/59S disk drives are supported only on an HP 98265A SCSI
Interface.
3. Set the Address.
a. On the back of the disk drive, find the address switches labeled
"ADDRESS" in the upper left corner.
b. Set the address to any unused address from 0 to 6 (the SCSI interface is
set to 7).
4. Connect the Disk Drive to Your Computer.
a. Attach the cable coming from the SCSI interface to one of the two
connectors on the disk drive (it does not matter which one). Press fully
m.
b. Place the terminator (supplied with the SCSI interface card) fully on the
other connector on the back of the disk drive.
c. If you have more than one one disk drive on the SCSI bus, the drives
should be daisy-chained, with the terminator on the last disk in the
chain.
5. Connect the Power Cord.
Connect the female end of the power cord to the power socket on the back
of the disk drive, and connect the other end to your power outlet.
6-110 Adding Mass Storage Devices