HP 98568A Installation Instruction page 293

HP 9121/9122 Flexible Disk Drives
• If there are two other disk or tape drives (besides this HP 9121/22)
already connected to the interface, set the "ADDRESS" switches to 3
as shown in Figure 6-17, unless address 3 has already been used. Refer
to the manual that came with your disk drive for additional switch
settings.
~ X'2.'
I •
• •
o
•
Address 3
Figure 6-17.
Address 3
c. Connect the Disk Drive to Your Computer.
Note
1.
Find the HP-IB cable provided with the disk drive.
11.
Connect one end of the HP-IB cable to the HP-IB socket on the back
of the disk drive. Tighten the thumb screws to secure the connection.
Ill.
Connect the other end of the HP-IB cable to the interface.
If the interface already has several cables connected to it,
connect your HP 9121/22 cable to one of the other devices on
the interface.
4. Connect the Power Cord.
Connect the female end of the power cord to the "AC LINE" socket on the
back of the disk drive, and connect the other end to your power outlet.
5. Record the Address.
Make a note that address 0 (or the alternate address you set in an earlier
step of this installation procedure) has been used and is no longer available
on the interface you selected. Use the "Address Record" form on the
Chapter 6, "Mass Storage" tab for this purpose.
Adding Mass Storage Devices 6-67