Installing An Active Interface Modules Chassis-2 - Siemens SINAMICS S120 Manual
Air-cooled chassis power units
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
9.4.2.2
Installing an Active Interface Modules Chassis-2
Description
To install Active Interface Modules Chassis-2 in a Rittal VX25 control cabinet, you require a
console and two mounting plates for the rear panel of the control cabinet.
Models of the individual parts are also available in the "DT Configurator", see "DT Configurator
(https://www.siemens.com/dt-configurator)".
The following data applies for creating the console.
• All punch geometry dimensions, where a tolerance is not specified, must have a tolerance
of ±0.3; other dimensions - where the tolerance is not specified - must have a tolerance
according to ISO 2768 m-K.
• All bending radii shown in the drawing without dimensions must have radius R4.
• All radii shown in the drawing without dimensions must have radius R4.
• All chamfers shown in the drawing without dimensions must be 5x45°
• Material for the console: EN10025-2 - S235JRC+N - 4 with galvanized surface coating.
• Punched edges should be deburred.
• You require 2 insert nuts, type PEM M10-H (number ① in the console drawing).
The following data applies for creating the mounting plates:
• All punch geometry dimensions, where a tolerance is not specified, must have a tolerance
of ±0.15; other dimensions - where the tolerance is not specified - must have a tolerance
according to ISO 2768 m-K.
• All bending radii shown in the drawing without dimensions must have radius R2.
• All chamfers shown in the drawing without dimensions must be 3x45°.
• Material for the sheet metal parts: EN10346-DX52D+Z140-M-B-CO-2.5.
• Punched edges should be deburred.
• For each mounting plate, you require 6 insert nuts, type PEM M10-H (number ① in the
mounting plate drawing).
To mount the individual parts, you also require in addition:
• 16 screws, type ISO14585 5.5x13 for fastening the mounting plate (number ② in the
installation drawing), e.g. Rittal No. VX 5051.018.
• 8 screws SN60736-C-M8x16 (number ③ in the installation drawing) with M8 captive nuts
(number ④, Rittal No. TS 4165.000) for fastening the console.
Air-cooled chassis power units
Equipment Manual, 06/2020, 6SL3097-5AE00-0BP3
9.4 Control cabinet installation for devices in the Chassis-2 format
Cabinet design and EMC
443
Advertisement
Table of Contents
