Siemens SIMATIC Ident Function Manual page 86

Configuring the instructions
4.6 Programming the Ident profile
Byte Value
86
RFID system Meaning
0x20 ISO 14443
1)
(MOBY E,
E6xx)
0x31 General mode
1)
(ISO, RF300,
MOBY E)
Note that individual settings or transponder families can be combined (e.g. ISO
15693 general + RF300). In this case, the relevant hex values need to be com-
bined (ISO 15693 general [0x01] + RF300 [0x10] = 0x11).
Note:
ISO 15693: The following ISO special functions are not supported:
•
– AFI (Application Family Identifier)
– DSFID (Data Storage Format Identifier)
– Chip-specific added functions such as EAS, Kill commands, etc.
ISO 15693: With "TAG_TYPE(ftim) = 0x01", the readers of the 1st generation
•
support the ISO commands "Inventory", "ReadSingleBlock", "WriteSingle-
Block", "LockBlock," "GetSystemInformation" and for multitags also "Select"
and "ResetToReady".
If a previously unknown transponder cannot be identified based on the parame-
•
ters above, an error message is generated (error_MOBY= "0x0D").
Invalid parameters are rejected with an error message ("error_MOBY= 0x15").
•
Applies only to readers of the 2nd generation.
1)
RF600 ETSI/India variant: 0x00 ... 0x0F
Changing the channel assignment in
the ETSI wireless profile ("scan-
ning_time = 0x02"):
e.g. MDS E600, E611, E623, E624
Activation of the so-called "General mode" for pro-
cessing the transponder types RF300, ISO 15693 and
ISO 14443. With this setting, operation is basically
guaranteed with every compatible transponder. If ISO
mode and RF300 mode are activated a transponder
can be processed up to maximum address "8192" even
if the RF300 transponder has a memory of 64 kB.
Changing the channel assignment in the
India wireless profile ("scanning_time =
0xC0"):
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03