Siemens SIMATIC Ident Function Manual page 109

Error mes- Description
sage
(hex)
0xE6FE85 Reserved
0xE6FE86 The inventory command failed.
0xE6FE87 Read access to the transponder has failed.
0xE6FE88 Write access to the transponder has failed.
0xE6FE89 Writing the EPC-ID on the transponder has failed.
0xE6FE8A Enabling write protection on the transponder has failed.
0xE6FE8B The "Kill" command failed.
0xE7FE01 In this status, only the "Reset_Reader" command ("WRITE-CONFIG") is permitted.
0xE7FE02 The "CMD" command code or the value in "CMD SEL" is not permitted.
0xE7FE03 The "LEN_DATA" parameter of the command is too long.
It does not match the global data reserved in the send data buffer (TXBUF).
0xE7FE04 The receive data buffer (RXBUF) or the send data buffer (TXBUF) is too small, the buffer created at
TXBUF/RXBUF does not have the correct data types or the parameter "LEN_DATA" as a negative value.
Possible cause / action to be taken:
Check whether the buffers TXBUF/RXBUF are at least as large as specified in LEN_DATA.
•
0xE7FE05 This error tells you that only an "INIT" command is permitted as the next command. All other commands
are rejected.
0xE7FE06 Wrong index (outside range of "101 ... 108" and "-20401 ... -20418")
0xE7FE07 The reader or communications module does not respond to "INIT" ("INIT_ACTIVE" is expected in the cy-
clic status message).
The next steps:
Check the address parameter "LADDR".
•
0xE7FE08 Timeout during "INIT"
(60 seconds according to "TC3WG9")
0xE7FE09 Command repetition is not supported.
0xE7FE0A Error during the transfer of the PDU (Protocol Data Unit).
0xFxFExx An "FxFExxh" error is identical to the corresponding "ExFExxh" error (see "ExFExxh" error).
Byte 3 contains additional warning information.
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 01/2019, C79000-G8976-C410-03
5.2 Errors from the communications module/reader
Error messages
109